More like this
0:21
#scoopz #foryou
Sophia
748
0:17
When someone finally decides to part with their most treasured art and memories. Faces that GO HARD! #BestOfTheInternet #
RawVibeSeekr
2.0k
0:20
Super glue prank on wife
USA_chronicles
47.0k
0:18
She was being racist' and got what she deserved 😂 Justified ??
Fight ON
132.4k
0:37
💥That was a lucky shot💥 #president #trump #politics #unpopularopinion #us created by BooWang with BooWang’s original sound
❤️💚 Ce7eN2k 💚❤️
6.5k
0:19
Would you Live here?
Daily Shorts
14.9k
0:16
Trump walks away after calling on a reporter 😎
Mr Nortey
1.4k
0:12
#police #policeofficer #policeofficers #policeclips #policevideo #policevideos #policecam #policebodycam #policechase #cop #cops #copwatch #copsusa #viral #viralvideo #fyp #fypシ #fypツ #fyp #fypp #fyppp #fypviral #fypage #foryou
Police Clips
372.1k
0:14
#fyp #foryou
OnlyCrazyVideos
66.9k
0:23
😂😂😂 Trump was a good comedian
Followpage10000followers
29.6k
33 Comments
Using your brain would be a starter 😭
need bigger hammer
You could sand it down just a bit
yea u need to take a grinder of some type and grind the sides down at a angle but the only reason it fits at the top is cause it's leaning out at the top
the bottom of both walls are too close
V
should've smoothed that left side an eighth of an inch
That's what she said
they aren't plumb and true jackass
Welp… That didn’t work. If You took the time to shave down the sides a little bit you would’ve look like a pro 👍
The posts aren't straight.
job one had bro
people really are this stupid😂
wrong way idiots!
either grind the sides, or use a board as cushion between the mallet and concrete piece so the impact won't crack it
perfect!😁 nail it
Shave the sides a little at an angle slightly so that on kinda matched the concave of the posts , I hope that makes sense , sorry if I butchered that , would someone who knows what I’m talking about please but my comment into understandable words please lol I d appreciate it , it makes perfect sense in my head I just can’t put it to words 😅sorry
Out of square just shave down the sides til you don’t need to no more that’s it right there my guy
Fail
😭😭😂😂
the next one will go now.
take a damn grinder to one of the sides, 4-5quick passes and have plenty of clearance
or reverse the stone. this stone was put in front side facing back. you can tell by tje angle of the cuts on the corners.
the best answer is to get a new brick
try getting everything wet. concrete might slide a little easier
At this point might as well take a harden fine and some elbow grease
grind off the long way inside the edg ore the grind off the blocks, it goes from small to larg is perfect!!
tapers
you just did it.. looks like it fits fine to me
Measurements are off somebody messed up your lay line prolly stepped on it that’s why you double even triple check measurements
Shave the sides with a sander