27 Comments

avator
stevtabares1
Selah, WA · 3 months ago

just as easy to press them caps on , the needles won't fall out of place as easy if you put some grease in the caps before

avator
Common Sense
Vancouver, WA · 3 months ago

done that many times.

avator
Gary Jackson
Winchester, IN · 3 months ago

what GenX'er doesn't know how to do this??

avator
Matt Borris
Jackson, NJ · 3 months ago

very proud of you I did that when I was 12

avator
Kelly
Kalispell, MT · 2 months ago

And?

avator
Nob0dY
Sahuarita, AZ · 3 months ago

lost skill

avator
LC31
3 months ago

all that hammering Doesn't it mess up that component???

avator
Leonard Thomas
Ada, OK · 4 months ago

Salty fingers destroy oil.

avator
Robert Montgomery
Deshler, OH · 3 months ago

wow. he actually replaced a u-joint. big fuckin deal.

avator
Tom
Minooka, IL · 4 months ago

Definitely not the correct way

avator
James Jones
Calhoun, TN · 5 months ago

First off I have no idea why all the bearing were taken off this universal joint? Electrical tape direction around end to end. the two not used before putting into the driveshaft yoke. This stops them from coming off accidently. Put the universal in the yoke and clip it. Just before putting the drive shaft in the differential yoke pull the take off.

avator
YoDaddy
Tulsa, OK · 4 months ago

Say you don't know how to do U joints without saying you don't know how to do U Joints

avator
Robert
Mililani Town, HI · 5 months ago

that guy needs 2 go bak 2 school thats not how u do it

avator
James Asbury
Wichita, KS · 4 months ago

been there done that

avator
John citizen
Vancouver, WA · 5 months ago

check needle bearings.

avator
Big AL
4 months ago

Oh dear

avator
Blowin Magoo
Marydel, MD · 4 months ago

Wtf That’s not how you do that he is hitting it

avator
Ian Zuczuski
El Paso, TX · 5 months ago

like I was told in high school that is the best way to lose all the needles in those caps

avator
James
Pittsburgh, PA · 5 months ago

I hated doing u-joints