Make screws flush in seconds with this easy hack! 🛠️ #DIY #LifeHack #Tips

snag1

Augusta, GA · 4 months ago

that's the dumbest thing i ever seen

JustJeepin

Lugoff, SC · 5 months ago

If only they made a bit to countersink screws…

Dan Prew

Prairie du Chien, WI · 3 months ago

If she treats all of her screw holes like that, she will have trouble keeping her bores flush.

Slim2004245

Alton, IL · 3 months ago

Why would you need 3 bits? If the thing was spinning wouldn’t 2 have reamed it out the same way? I don’t even care.. I’m angry this was ridiculous no matter what.. 🐂💩

Michael Barlow

Dallas, TX · a day ago

they make tapered bits for that reason

Dustin Niemeier

Benson, MN · 3 months ago

well; I'm sorry to say that it "ain't gonna work" on a steel plate. Better get a 135° (or whatever degree bit that equals the taper on the bottom side of the head of the screw) chamfer/countersink bit, or at least get a "couple o' sizes bigger" drill bit to create the countersink relief for the head of the screw to then sit flush with; or just below the surface of the board.

Donn Griffith

Chiefland, FL · 3 months ago

so... why not just get the correct countersink tool??

Robert Carvalho

Miami, FL · 3 months ago

that is very unique. i love it and will use it

Greg

4 months ago

This has to be a troll post ...negative attention is still attention

Tobyg8169

Tyler, TX · 4 months ago

Wow

bryant

5 months ago

or use one bigger drill bit

Jim

5 months ago

before you put the screw in take the screw bit head and put it in the hole you're going to put screw in and ream it and put screw in it it will flush it